Hestan KDW24-OV Use and Care Manual download pdf (Page 30)

CLEANING THE WATER INTAKE FILTER

CLEANING THE SPRAY ARMS

CLEANING AND USER MAINTENANCE

(continued)

Clean the water inlet lter at regular intervals. After closing the delivery tap, unscrew

the ring nut (A ) on the water inlet pipe (using a pair of pliers, if necessary) and

and delicately clean the lter, removing deposits or impurities.

Then rmly x the pipe by tightening the ring nut (use a pair of pliers if necessary).

The spray arms can be easily removed for periodic cleaning of the nozzles, to

prevent possible clogging. Wash them under running water (at room temperature)

and carefully replace them in their seats, checking that their rotary movement is in no

way impeded; if this is not the case, make sure they have been mounted properly.

Removing the spray arms

•

To remove the upper spray arm (A), unscrew the locking ring (B )

by turning it clockwise. After cleaning, remount the spray arm in its seat

and tighten the locking ring by turning it anti-clockwise.

•

To remove the orbital spray arm assembly (A ), take hold of the lower

arm (B ) and pull the orbital unit upward.

After cleaning, remount the orbital spray arm in its seat and push it down slightly

until it clicks into place on the lower spray arm. Then remount the lower

spray arm into its seat and push it down slightly until it click into place.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 75 76

No comments

Hestan KDW24-OV Use and Care Manual Page 30