Hestan KSO30 Installation Manual download pdf (Page 7)

TO REMOVE OVEN DOOR

1. Open oven door completely.

2. At each hinge location, swing the hinge retainer (1) up until it stops. A screwdriver may be

needed to do this.

3. Gently close the oven door until it stops against the hinge retainers. It will be nearly closed

and the upper edge of the door will be slightly higher than the opening.

4. Hold on firmly to both sides of the door (not the handle) and pull the door straight up to

release the hinge arms, then pull the door away from the oven. Place the oven door in a

safe location until needed.

• NEVER release the hinge retainers and try to close the hinges. Doing so will snap the

hinges closed with great force which could cause injury.

TO RE-INSTALL OVEN DOOR

1. Hold the door firmly on both sides (not from handle) at approximately 30° from the closed

position and insert the hinges into the slots (3) in the oven.

2. The bottom edge of each hinge (2) has a notch (4) which must engage on the lip (5). DO

NOT FORCE OR BEND OR TWIST THE DOOR!

3. Slowly open the door all the way.

4. Swing each hinge retainer (1) down until completely inside the slot opening and fully

seated. A screwdriver may help you do this. NOTE: The hinge retainer will not swing into

the slot opening unless the hinge arm is fully seated.

5. Gently close the oven door to check for smooth operation.

TO REMOVE THE DOOR

TO REPLACE THE DOOR

LOCATION AND INSTALLATION

(continued)

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

No comments

Hestan KSO30 Installation Manual Page 7