Hestan KWD30 Use and Care Manual download pdf (Page 17)

INSTALLATION

APPLIANCE INSTALLATION

IMPORTANT: Save these instructions for the local electrical inspector use.

INSTALLER: Please leave this manual with owner for future reference.

OWNER: Please keep this manual for future reference.

If the information in this manual is not followed exactly, a fire or explosion may result causing

property damage, personal injury or death.

Please read these instructions COMPLETELY AND CAREFULLY. They will save you time and

effort and help to ensure optimum drawer performance.

Be sure to observe all CAUTIONS and WARNINGS. These installation instructions are intended

for use by a qualified installer.

• Assure that electrical installation is adequate and in conformance with National Electrical

Code, ANSI/ NFPA 70 - latest edition**, or Canadian Electrical Code, part 1 C22.1 (latest

edition)*** and all local codes and ordinances.

These shall be carefully followed at all times.

TOOLS YOU WILL NEED

• The following tools are needed to install your new warming drawer:

• Tape measure and straightedge or ruler

• Pencil

• Phillips screwdriver

• Level

• Wire cutters and wire stripper

• Hand or saber saw

• 1” (2,5cm) Hole saw

• Drill and drill bit

• Safety gloves and goggles

• Volt meter (0-250VAC)

PACKAGING

Remove all tape and packaging before using the warming drawer.

Destroy the packaging after unpacking the drawer following the rules in force in your locale.

Never allow children to play with packaging material.

POWER REQUIREMENTS

The warming drawer must be supplied with the proper voltage and frequency. The drawer

is manufactured to be connected to a three-wire, single phase, 120 Volt, 60 Hz AC electrical

supply.

POWER REQUIREMENT

Voltage 120 Volts, 60 Hz

Current 9.2 Amperes

Consumption 1100 Watts

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

No comments

Hestan KWD30 Use and Care Manual Page 17