Hestan KDW24-OV Installation Manual download pdf (Page 12)

CONNECTING TO A WASTE DISPOSAL WITHOUT AN AIR GAP

CONNECTING TO THE OUTLET

MAKE THE CONNECTION UPLINE FROM THE SIPHON OF THE

DRAIN LINE AND AT LEAST 15-3/4” (400 mm) ABOVE THE FLOOR

ON WHICH THE DISHWASHER WILL BE INSTALLED.

Remove the cover of the waste disposal unit (A) .

Connect the dishwasher drain hose (B ) to the waste disposal unit inlet (C),

* Available from any plumbing store

using the wide spring clamp (D).

RATINGS ON THE NAME PLATE OF THE APPLIANCE, WHICH IS POSITIONED

ON THE INNER EDGE OF THE DOOR.

IN THE EVENT OF DAMAGE TO THE SUPPLY CORD, HAVE IT REPLACED

BY THE MANUFACTURER OR AN AUTHORIZED TECHNICIAN.

THIS APPLIANCE MUST BE GROUNDED. IN CASE OF A MALFUNCTION

OF FAULT, THE GROUND REDUCES THE RISK OF ELECTROCUTION BY

BY PROVIDING THE ELECTRICAL CURRENT WITH AN ALTERNATIVE,

LESS RESISTANT PATH. THIS APPLIANCE IS FITTED WITH A POWER CORD

CONTAINING A GROUND WIRE AND PLUG. FIT THE PLUG INTO A

SUITABLE OUTLET, INSTALLED AND GROUNDED IN COMPLIANCE WITH

LOCAL CODE.

BEFORE MAKING ELECTRICAL CONNECTIONS, DISCONNECT THE

MAIN POWER SUPPLY FROM THE WORK AREA.

CHECK THAT VOLTAGE AND FREQUENCY OF THE OUTLET MATCHES THE

WARNING AN INCORRECTLY CONNECTED GROUND WIRE MAY

GENERATE THE RISK OF ELECTROCUTION. IF IN DOUBT AS TO

THE CORRECT GROUNDING OF THE APPLIANCE, CALL IN A

QUALIFIED ELECTRICIAN OR THE TECHNICAL ASSISTANCE

SERVICE. DO NOT CHANGE THE PLUG ATTACHED TO THE

APPLIANCE.

THE PLUG AT THE END OF THE POWER CORD AND THE CORRESPONDING

OUTLET MUST BE OF THE SAME TYPE AND MUST CONFORM TO LOCAL

REGULATIONS GOVERNING ELECTRICAL APPLIANCES. NEVER REMOVE THE

PLUG BY PULLING ON THE CORD.

LOCATION AND INSTALLATION

(continued)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

No comments

Hestan KDW24-OV Installation Manual Page 12