Hestan KDW24-OV Use and Care Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 76
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
FEATURES AND CONTROLS
(continued)
on the cycle selection button for a few seconds until the indicator lights of
the fourth and fth cycles turn on.
Close the door again.
After about 1 minute, the dishwasher stops the cycle and the indicator
lights of the fourth and fth cycle begin to ash.
The end of the program is signaled by a short beep. Additionally the indicator
light of the normal and strong wash programs (marked “end” ) will flash.
PROGRAM IN PROGRESS INDICATOR LIGHT
When a program is running, a flashing light is projected onto the floor un-
der the right-hand corner of the door. At the end of the program, the light
goes out to reduce sleep mode electricity consumption.
To interrupt the current program simply open the door of the dishwasher;
to restart the program, simply close the door again. The program restarts
from where it was interrupted.
To change the current program, simply open the door of the dishwasher
and select the new program. Close the door to run the new program
automatically.
END OF WASH CYCLE
INTERRUPTING A WASH CYCLE
CHANGING THE CURRENT WASH CYCLE
CANCELLING THE CURRENT WASH CYCLE
END OF CYCLE LED PROJECTION INDICATOR
To cancel the current program simply open the door then press and hold down
Delicate
Daily Wash
Super/
Sanitize
Crystal
Soak
Options:
Function designed for loads with hard to dry item such as saucepans, nonstick
pans and plastic containers. Increases the hot rinse temperature and can be
used in programs featuring a nal drying phase (see WASH CYCLES table).
(available for all programs except soak)
The DELAY START function delays the beginning of the wash cycle up to
24 hours beginning from the moment the delay programming is entered.
This makes it possible to use the dishwasher at a specic time of day.
Before programming a delay, open the door of the dishwasher and select the
required washing program. Select the day by pressing the Delay button.
Each time you press the button, the display increases the delay before the
appliance starts by 1 hour.
DELAY START
12
©2018 Hestan Commercial Corporation
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 75 76

Comments to this Manuals

No comments